Valor Fires 820 Longlite Installer And Owner Manual - Method B - Wire Fix.
marked positions. Insert wall plugs into the drilled
holes.
5. Place the heater so that the slotted holes are in
line with the wall plugs in the fixing surface.
6. Screw and secure the heater with two wood
screws (See figure 3).
Method B - Wire fix.
This method of fixing needs a fireplace opening
and is recommended when fixing the heater to a
marble surround or where the wall or brickwork is
in poor condition.
1. The fixing kit supplied with the heater includes
a steel wire and eyescrew (See figure 3). These
can be used to secure the heater to the back of a
fireplace opening.
2. Mark the eyescrew position on the
centre line at the back of the fireplace
opening and at a height of 533-560mm
(21 inches - 22 inches) (See figure 6).
3. Drill an appropriate size hole in the
marked position.
4. Insert a wall plug into the drilled
hole.
5. Screw the eyescrew into the wall
plug.
6. Position the heater in front of the
fireplace opening.
7. At the top of the heater there are
four small holes, two each side of the
heater (See figure 7 - Item 1). From
the front of the heater, thread about
50mm ( 2 inches) of the steel wire into
the inside small hole on the left side of
the heater (See figure 7 - item 2).
8. Thread the other end of the wire
through the remaining small hole on
the left hand side of the heater.
Continue to push the wire through this
hole until there is only a small loop of
wire at the front of the heater (See
figure 7 - item 3).
Page 10
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2010.
Figure 7. Steel wire fixing (Detail at top of
heater may differ from that shown)
Figure 6. Eyescrew position.