Valor Fires 820 Longlite Installer And Owner Manual - Fitting The Fascia
Fitting the heater.
1. Locate the spacer frame and
heater over the screw heads ensuring
a tight fit. If the fit is loose, remove the
spacer frame and heater from the
wall. Tighten the wall screws slightly
and reposition the spacer frame and
heater.
Fitting the light diffuser.
1. There is a light diffuser supplied
with the heater (See figure 3). Place
this on to the metal flange below the
plastic screen (See figure 10).
Fitting the Fascia
Blenheim model.
1. Removing the fascia trim may have moved the
magnets used to fix it to the heater. The magnets
should be located as in figure 11.
2. Locate the fascia onto the heater. Ensure that the
sides of the fascia sit on the floor / hearth.
3. There are two hanging screws on the rear of the
firefront. Locate these into the slots as in figure 12.
4. Place the one piece fuel effect on top of the firefront
fuel support.
Page 12
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2010.
Figure 12. Firefront location
Figure 11.
Figure 10. Diffuser location