Valor Fires 820 Longlite Installer And Owner Manual - Fitting The Control Knob.
Fitting the Control Knob.
The control knob is supplied separately with
the accessory pack. Fit the control knob
before continuing with the heater
installation. To assemble the control knob to
the control spindle, firstly line up the ‘D’
profile on the underside of the control knob
to the ‘D’ profile on the spindle (both flats
should line up). Place the control knob onto
the spindle and gently push until the control
knob is fully located.
The heater must be fixed into position to prevent it from being tipped over
The following fixing options are available:
Screw Fixing.
Wire Fixing.
Spacer Frame*.
* An optional spacer frame kit is obtainable either from the your heater supplier or
direct from Valor Fires Sales. The kit is a 75mm (3 inch) spacer kit (Kit number
05801T1).
If fitting the heater into a fireplace or surround opening, try the heater in the opening
to ensure that it will fit.
If fitting the heater onto a decorative hearth surface such as marble or tile it is
advisable to protect the hearth surface. Do not drag the heater across the surface of
the hearth as this may scratch the hearth surface.
Method A - Screw fixing.
Note - If fixing to marble it is recommended that
Method B - ‘Wire fixing’ is used. Drilling marble
without the correct tools and experience may
result in the marble cracking.
1. Place the heater into the fireplace or surround
opening
. Make sure that the heater is in the
middle of the surround or fireplace.
2. There are two slotted holes in the top of the
heater (See figure 5). Mark through the slotted
holes so that their position is clear when the
heater is removed.
3. Remove the heater.
4. Drill an appropriate size hole in each of the
Page 9
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2010.
Figure 5. Slots for screw fixing.
Figure 4.