Valor Fires 820 Longlite Installer And Owner Manual - 4. Using The Heater
4. USING THE HEATER
Important Safety
Never cover the heater or obstruct the openings at the base of the heater, this
could cause overheating and consequent risk of fire.
What are the three switches for?
The heater is operated by three switches located below the hood on the left hand side
of the heater.
Switch 1 =
Main On - Off. (In the ‘ON’ position, only the flame
effect operates)
Switch 2 =
1kW fan heat setting and flame effect. (Switch 1 needs
to be in the ‘ON’ position to enable switch 2 to operate).
Switch 3 =
2kW fan heat setting and flame effect. (Switches 1 & 2
need to be in the ‘ON’ position to enable switch 3 to
operate).
What is the knob for?
The heater has a variable energy control located below the hood on the right hand
side of the heater.
The variable energy control will only work when all three switches are on. If the room
requires maximum heat, rotate the control fully clockwise. For less heat rotate the
control counterclockwise until the required heat setting is achieved. When operating
the variable energy control will operate between the 1kW and 2kW settings. Turning
the knob fully counterclockwise will switch the variable energy function off.
Page 14
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2010.
Figure 15. Controls