Valor Fires 824 Blenheim Longlite Installer And Owner Manual - 3. Fitting The Heater
Important! This heater must be earthed.
The heater is supplied with a 3 pin 13 Amp fused re-wireable plug with 1mm² 3
core cable.
The wires in the cable are coloured in accordance with the following code: -
Live = Brown
Neutral = Blue
Earth = Green / Yellow
The electric cable must be safely routed from the heater to an electrical socket.
If the electric cable is damaged, to avoid a hazard it must be replaced by a Valor
Fires authorised service agent, or similarly qualified person. All external wiring
between the heater and the electrical supply shall comply with current IEE
regulations. Extension leads should not be used.
3. FITTING THE HEATER
The installation of this heater requires a reasonable level of DIY skills.
Please read this guide thoroughly before commencing installation and if in
doubt, seek help from a competent person.
Important: Before continuing with the installation of this heater please ensure
that you have completed the information on the last page of this guide.
Do I need any tools?
1. Depending upon the chosen method of installation you may need the following
tools: -
A Hexagonal Key (Supplied with the heater).
A Pozidrive / Phillips / cross head screwdriver. This should have a number 2
size tip.
2. If drilling into brickwork you will need a power drill (preferably with hammer action)
and appropriate size drill bit for the wall plugs supplied.
Where can I fit the heater?
This heater can be fitted into fireplaces or surrounds where the following dimensions
are available.
Width
400mm - 450 mm (15.35 inches - 17.72 inches)
Height
555mm - 590 mm (21.9 inches - 23.2 inches)
Depth
At least 75mm (At least 3 inches)
An optional spacer frame kit is obtainable either from your heater supplier or direct
from Valor Fires Sales. The kit is a 75mm (3 inch) spacer kit (Kit number 0582631).
Page 5
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.