Valor Fires 824 Blenheim Longlite Installer And Owner Manual - Fascia Support Brackets.
The heater must be fixed into position to prevent it from being tipped over
The following fixing options are available:
Screw Fixing.
Wire Fixing.
Spacer Frame*.
* An optional spacer frame kit is obtainable either from your heater supplier or direct
from Valor Fires Sales. The kit is a 75mm (3 inch) spacer kit (Kit number 0582631).
If fitting the heater into a fireplace or surround opening, try the heater in the opening
to ensure that it will fit.
If fitting the heater onto a decorative hearth surface such as marble or tile it is
advisable to protect the hearth surface. Do not drag the heater across the surface of
the hearth as this may scratch the hearth surface.
Fascia support brackets.
As supplied the fascia support brackets may be flat against the heater body. Using a
suitable tool or gloved hand bend the brackets as
in figure 3.
Method A - Screw fixing.
Note - If fixing to marble it is recommended that
Method B - ‘Wire fixing’ is used. Drilling marble
without the correct tools and experience may result
in the marble cracking.
1. Place the heater into the fireplace or surround
opening
. Make sure that the heater is in the middle
of the surround or fireplace.
2. There are two slotted holes in the top of the
heater (See figure 4). Mark through the slotted
holes so that their position is clear when the
heater is removed.
3. Remove the heater.
4. Drill an appropriate size hole in each of the
marked positions. Insert wall plugs into the
drilled holes.
5. Place the heater so that the slotted holes are
in line with the wall plugs in the fixing surface.
6. Screw and secure the heater with two wood
screws (See figure 2).
Page 8
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.
Figure 4. Slots for screw fixing.
Figure 3. Fascia support
brackets