Valor Fires 824 Blenheim Longlite Installer And Owner Manual - Method B - Wire Fix.
Method B - Wire fix.
This method of fixing needs a fireplace opening and is recommended when fixing the
heater to a marble surround or where the wall or brickwork is in poor condition.
1. The fixing kit supplied with the heater includes a steel wire and eyescrew (See
figure 2). These can be used to secure the heater
to the back of a fireplace opening.
2. Mark the eyescrew position on the centre line
at the back of the fireplace opening and at a
height of 533-560mm (21 inches - 22 inches) (See
figure 5).
3. Drill an appropriate size hole in the marked
position.
4. Insert a wall plug into the drilled hole.
5. Screw the eyescrew into the wall plug.
6. Position the heater in front of the fireplace
opening.
7. At the top of the heater there are four small
holes, two each side of the heater (See
figure 6 - Item 1). From the front of the
heater, thread about 50mm (2 inches)
of the steel wire into the inside small
hole on the left side of the heater (See
figure 6 - item 2).
8. Thread the other end of the wire
through the remaining small hole on
the left hand side of the heater.
Continue to push the wire through this
hole until there is only a small loop of
wire at the front of the heater (See
figure 6 - item 3).
9. At the back of the heater there will
be a long piece and a short piece of
wire coming through the two holes.
Hold the short piece and give the long
piece a gentle tug. This will secure the
steel wire. Take the long piece and
thread this through the eyescrew in the
back of the fireplace opening (See
figure 6 - item 4).
10. From the back of the heater thread
the long piece of steel wire through the
outer small hole on the right hand side
Page 9
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.
Figure 6. Steel wire fixing (Detail at top of
heater may differ from that shown)
Figure 5. Eyescrew position.