Valor Fires 824 Blenheim Longlite Installer And Owner Manual - Moving The Cable Guide.
Moving the cable guide.
At the base of the heater you will find an electric cable which runs through a
rectangular plastic cable guide. As supplied the cable guide is fitted into the
rectangular cut-out on the right side of the heater. If required, the cable guide can be
removed and put in the rectangular slot in the centre or left hand side of the heater.
For removal and fitting please see the following sections.
Removing the cable guide
1. Before removing the cable guide please note that
the wider part of the cable guide is on the outer
edge of the base (See figure 1 - Item 1).
2. To remove the cable guide push and lift the tab
on the bottom. The bottom of the cable guide will
open (See figure 1 - Item 2).
3. Lift the electric cable clear of the cable guide.
4. Hold the bottom of the cable guide close to the
heater then gently pull the cable guide away from
the rectangular slot (See figure 1 - Item 3).
Fitting the cable guide.
When fitting the cable guide please remember that
the wider part of the cable guide has to be fitted
against the outer edge of the base (See figure 1-
Item 1).
1. Gently pinch the sides of the cable guide (See
figure 1 - Item 4) and push the cable guide into the
required rectangular slot.
2. Place the electrical cable into the guide and close
the top of the cable guide.
Page 6
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.
Figure 1. Removing and
positioning the cable guide.
Item 1
Item 2
Item 3
Item 4