Valor Fires 844 Installer And Owner Manual - 0584081
Method D - Securing with the optional spacer frame supplied in kit
0584081
.
The optional spacer is for use where a flat wall
installation is required (Not applicable on Regalia
model).
1.
There are four screws supplied with the
optional spacer frame. The narrow flange of the
optional spacer should be placed against the
spacer supplied with the heater. Screw the
optional spacer frame to the one supplied with
the heater (See figure 9).
Note: The optional spacer is smaller than the one
supplied with the heater.
2.
The top rear flange of the spacer frames has
two screw locations. Mark the positions of the
two screw locations on the rear wall (See figure
7- This only shows one spacer).
3.
Remove the spacer frames from the fireplace
and place away from the work area.
4.
Drill the screw locations using a suitably sized
masonry drill bit for the wall plugs supplied.
5.
Insert two wall plugs provided into the holes.
6.
Insert a wood screw into each hole (See figure
3) and screw in until there is approximately 6mm
of screw protruding from the wall.
7
. Secure the spacer frames to the heater using
four No.8 x 3/8 screws supplied (See figures 9
and 3).
8.
Carefully lift the heater and locate the slots on
the rear of the spacer frame onto the screws in
the wall. The screws can be adjusted to ensure a
tight fit. When mounting to decorative surfaces
such as wallpaper be careful not to drag the
heater down the wall as this may damage the
decorative surface.
Page 13
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2009.
Figure 9. Fitting the optional
spacer frame to the heater