Valor Fires 844 Installer And Owner Manual - Do I Need Any Tools?
4. FITTING THE HEATER
Please read this section thoroughly before positioning the heater.
Do I need any tools?
Depending upon the chosen method of installation you may need the following tools: -
For Spacer frame or screw fixed installations you will need
A Pozidrive / Phillips
/ cross head screwdriver
. This should have a number 2 size tip.
If wire fixing and drilling into brickwork you will need a power drill (preferably with
hammer action) and appropriate size drill bit for the wall plugs supplied.
Where and how can you fit the heater?
Q
Can the heater be installed into a ‘hole in the wall’ (elevated opening)?
A
The heater is suitable for ‘hole in the wall’ installations; these being installations
where the heater is recessed into a builders opening.This is
not
referring to the
heater being hung on the wall. It is important that the electrical socket is
accessible and located adjacent to, but not above or behind the heater.
(The Classica and Regalia fascias have been designed for traditional installations
where the base of the fascia sits on a hearth or similar surface. For this reason
we recommend that a plinth be fitted under the heater).
Q
Do you want to fit the heater into a surround or fireplace opening without
the spacer frame?
A
The minimum rebate / depth required is
145mm.
Q
What opening size do you need in the surround or fireplace opening?
A
This heater can be fitted into fireplaces or surrounds where the following
dimensions are available.
Width
395mm - 450 mm
Height
555mm - 590 mm
Depth
At least 145mm
Q
Do you want to fit the heater into a surround using the spacer frame
supplied with the heater?
A
The minimum rebate required is 71mm. This method is not applicable on the
Regalia model.
Page 7
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2009.