Valor Fires 844 Installer And Owner Manual - Important Electrical Safety
Always
Always
install the heater in accordance with this guide. If in doubt obtain
expert advice.
Always
make sure the electrical socket is accessible and located adjacent to, but
not above or behind the heater.
Always
disconnect the heater from the electrical supply before carrying out
cleaning or maintenance.
Always
use a fireguard when young children and infirm persons can come into
contact with the heater.
Always
use genuine Valor Fires spares.
Never
Never
leave children unsupervised in a room where the heater is ON and
unguarded.
Never
obstruct or cover the fan outlet or force items into heater openings.
Never
install or use the heater anywhere where water is in use, i.e.
Bathrooms, Kitchens, Shower Rooms, Swimming Pools etc.
Never
use aerosols or steam cleaners on or around the heater.
Never
route the electric cable under carpet etc.
Never
install the heater close to curtains or combustible materials.
Never
use the heater to dry clothes etc.
Never
sit or stand on the heater.
Never
use the heater with a timer switch or similar device.
Important Electrical Safety
The heater must
not
be located in front of or under an electrical socket, the socket must
always be accessible in order to disconnect the heater from the electrical supply for
maintenance and cleaning.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut out,
this appliance must
not
be supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on and off by the utility.
Important! This heater must be earthed.
The heater is supplied with a 3 pin 13 Amp fused re-wireable plug with 1mm²
3 core cable.
The wires in the cable are coloured in accordance with the following code:-
Live =
Brown
Neutral = Blue
Earth =
Green
/Yellow
The electric supply must be safely routed from the heater to an electrical socket.
If the electric cable is damaged, to avoid a hazard it must be replaced by a Valor Fires
authorised service agent, or similarly qualified person
.
All external wiring between the
heater and the electrical supply shall comply with current IEE regulations. Extension
leads should not be used.
Page 5
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2009.