Valor Fires 844 Installer And Owner Manual - What Does The Button Do?
Pressing the red ‘ON/OFF’ button.
Pressing this button at any time whilst the
effect and heater are in
operation will turn the
effect and heater off.
Manual Control - What is it and why is it there?
The manual control is there as a back up. If the remote control has been damaged,
lost, or the batteries life has expired, the manual control will enable the
effect and heater to be operated.
The control is located at the bottom left hand corner of the heater.
What does the button do?
Press the button once.
This turns the
effect on. Once the button is released the lamp will
flash amber for approximately five seconds, after this time the lamp will no longer be
visible.
Press the button a second time.
This turns the
effect and heater on. Both the status lamp and
thermostat lamp turn red and flash for approximately five seconds, after this time the
lamps will no longer be visible. The heater is now on high setting.
Pressing and holding the button a third time will adjust the thermostat range and
thermostat lamp as below:
Thermostat lamp colour
Thermostat setting
Green Low
Amber Medium
Red
High
Press the button a fourth time.
This turns the heater and
effect off.
Page 19
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2009.
Figure 18. Indicator lamps