Valor Fires 844 Installer And Owner Manual - Fitting The Cable Clamp.
Q
Do you want to fit the heater against a flat wall with the base of the heater
on a hearth or similar surface?
A
You will need to purchase the optional spacer frame kit (kit number
0584081).
This spacer when added to the one supplied with the heater enables the heater
to be flat wall fixed.
The depth of the combined spacer frames is 145mm.
This
method is not applicable on the Regalia model.
Q
Do you want to wall mount the heater against a flat wall?
A
You will need to purchase the
Optional spacer frame kit
(kit number
0584081)
and an
Elevated installation kit
(kit number
0584091).
The optional spacer
when added to the one supplied with the heater covers the full depth of the
heater rear (
145mm).
This method is not applicable on the Regalia model.
General notes to read before fitting your heater.
There should be at least 50mm clearance between the top of the fascia and
anything such as a shelf, fireplace surround or mantel etc. This will allow the fascia to
be lifted off or removed during servicing. To check the shelf clearance gently place
the fascia against the surface to which it is to be fixed and measure the distance from
the top of the fascia.
If fitting the heater onto a reflective or shiny
surface such as a hearth we recommend that this
surface does not extend further than 300mm from
the fixing plane (wall). Reflective or shiny surfaces
that project further than 300mm may reflect an
image of the internal lamp.
Fitting the cable clamp.
If the mains cable is to be routed to the left hand
side of the heater there is a cable clamp supplied
with the heater to hold the cable in place. This
prevents the cable being trapped under the heater
during installation. Fit the cable clamp as in figure 1.
Fitting the batteries to the Remote Control Handset.
The remote control handset uses 2 x 1.5V AAA type
batteries. For longer battery life use only alkaline
batteries. To install the batteries, slide the cover
down on the rear of the handset and remove (See
figure 2). The polarity of the batteries is marked on
the inside of the battery compartment.
If the heater does not respond to the remote control
handset commands, it is likely that the batteries are
faulty or require replacement.
Page 8
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2009.
Figure 1. Fitting the cable clamp
Figure 2. Battery cover removal