Valor ITS-703W Owner's Manual - page 7
TFT Monitor Operation
Open/Close TFT Monitor
Press the (
) button on the front panel or on the front zone remote control to open/close the
Monitor.
TFT Monitor Auto Open
If “TFT Auto Open” is “On”, when the unit is turned on, the monitor automatically opens to the
last viewing position, and closes automatically when the unit is turned off.
If “TFT Auto Open” is “Off”, when the unit is turned on, the monitor will not open automatically,
but will close automatically when the unit is turned off. You can press the (
) button on the
front panel or on the remote control to move the monitor into the desired viewing position.
If “TFT Auto Open” is “Manual”, when the unit is turned on or turned off, the monitor has no
Movement.
See “General setting” for details.
Monitor Tilt Angle Adjustment
The monitor angle can be adjusted for optimum viewing using one of the following methods:
Press the (
) or (
) buttons on the front panel to adjust the tilt angle of the screen one step
at a time.
Press and hold the (
) or (
) buttons to continuously adjust the tilt angle. Adjust the “Screen
Tilt” in the “Screen setting” to adjust the tilt of the screen to the desired degree.
Camera Mode
When the vehicle is placed in "Reverse", and an optional rear camera is connected to the unit,
the TFT monitor will automatically switch to the camera input source.
Image Setting
Video Output Format
The table below shows the video output format for each source.
Adjustable Parameters
While on RGB mode, the only parameter that can be adjusted is brightness (BRIGHT). To
access “PICTURE”, “COLOR”, “CONTRAST”, and “TINT” you must be on CVBS mode.
Parameter Adjustment Procedure
1. Enter Picture Quality Setting Mode:
Press the PIC button on the remote or press and hold the INFO button on the front panel of the
Unit.
2. Select Items to Set:
Press the (
) buttons on the remote or rotate the SMART DIAL button
clockwise/anticlockwise to select an item.
8
7