Vantage Hearth CC-STAT Installation Manual - page 11
SECTION ONE - Installation
CC-STAT
©Vantage, 41184 / IS-1308191-A
page 9 of 23
Station Bus Connection
The CC-WLINT connects to the Vantage System Station Bus using the two black wires labeled
Station Bus. The Station Bus wire should comply with the Vantage station bus specification*. The
CC-RLINT connects to the Vantage System via a RadioLink enabled system.
* Vantage Station Bus Wire Specification
2C, 16AWG / 1.31mm2, twisted, non-shielded, <30pF per foot. Separate a minimum
of 12" / 30.5cm from other parallel communication and/or high voltage runs.
Mounting the CC-WLINT or CC-RLINT
The CC-WLINT or CC-RLINT may be mounted behind the thermostat in a single gang box or may
hang through a small hole in the wall. The CC-WLINT or CC-RLINT does not supply power to the
thermostat.
Configuration
When the CC-WLINT or CC-RLINT is properly connected and powered the status LED will have a
two blink pattern for the WireLink model or a three blink pattern for the RadioLink model which
typically means it is not configured. NOTE: The LCD screen does not indicate that it is not
configured. From Design Center, with the station highlighted, click on the Configure Stations
button on the toolbar menu and wait for the station to display the following scrolling message,
PRESS HOLD TO CONFIGURE / VANTAGE CONFIGURATION. Press and release the HOLD
button, wait for one or two seconds, and verify that the serial number was populated in Design
Center. Repeat if necessary. Two additional ways to configure: 1) Follow the steps above but
press the configure button on the CC-WLINT or CC-RLINT station. The button is located on the
same side as the LED lights, near the middle of the board as illustrated below. The button may be
pressed by pressing the shrink-wrap directly over the button. 2) The station may also be
configured by typing the serial number in
the project file, using this method the
station will automatically be configured
when the system is programmed. Once
configured the status LED on the CC-
WLINT or CC-RLINT will blink evenly.
Status LED Diagnostic Information for CC-WLINT or CC-RLINT
During setup and configuration the CC-WLINT or CC-RLINT LED will blink at different intervals.
The STATUS LED blinks evenly or flashes 2, 3, 4, 5, or 6 times followed by a pause to indicate
status information.
One Even blink: The CC-WLINT or CC-RLINT is correctly configured on programmed system.
Two blinks: CC-WLINT or CC-RLINT is operating correctly but is not configured.
Three blinks: CC-WLINT or CC-RLINT is not communicating with the Controller. For the CC-
WLINT, verify that station bus wiring conforms to Vantage guidelines. For the CC-RLINT, verify
that the serial number is correct in the software and is in communication range with the
RadioLink Enabler.
Four blinks: CC-WLINT or CC-RLINT Factory problem. Please contact the factory.
Five blinks: CC-WLINT (only) Configuration mode.
Six blinks: Thermostat is not connected to the base after system has been programmed.
Configure Button