Vantage Hearth CC-STAT Installation Manual - page 5
SECTION ONE - Installation
CC-STAT
©Vantage, 41184 / IS-1308191-A
page 3 of 23
2-WIRE
Thermostat Cable
(R=Red, W=White
2-WIRE
Thermostat Cable
(R=Red, W=White
Remote Temperature Sensors (Optional)
A remote indoor temperature sensor can be used if the thermostat is to be mounted in a
concealed location. A Vantage flush mount sensor, part number FLUSHSENSOR, or surface
mount sensor, part number SENSOR-SMT, can be attached to the T1 and T2 terminals and
mounted in a recommended area. The remote sensor must be enabled in the installer set-up
menu, and once enabled will override the thermostat’s internal temperature sensor. (See Installer
Setup Menu in SECTION TWO – SETUP & TESTING). For temperature averaging connect 4 or 9
indoor sensors as illustrated below.
Remote temperature sensor should be
mounted:
On an interior wall, in a frequently
occupied space.
Approximately 5‘ above floor.
At least 18” from outside wall.
Using less than 300’ of wire.
Do not mount remote sensor:
Behind doors, in corners or other dead air
spaces.
In direct sunlight, near lighting fixtures, or
other appliances that give off heat.
On an outside or unconditioned area wall.
In the flow of a supply register, in
stairwells, or near outside doors.
On a wall with concealed pipes or
ductwork.
Near 120 VAC lines
Temperature Averaging
Connect Multiple Thermostat Sensors for Temperature Averaging.
Only 4 or 9 sensor configurations are allowed for averaging. Only wire multiple sensors as shown.
FOUR SENSOR TEMPERATURE
AVERAGING – SCHEMATIC
4 sensors, (see additional
information shipped with sensor)
NOTE 1: Wiring shown is using
model FLUSHSENSOR. Use the
same wiring for model SENSOR-
SMT.
NINE SENSOR TEMPERATURE
AVERAGING –
SCHEMATIC
9 sensors, (see
additional information
shipped with sensor)
NOTE 2: Temperature
averaging using the
CC-TEMPSUP support
module’s built-in
temperature sensor
allows averaging 2, 3,
or 4 sensors. See
additional instructions
packaged with
support module.
Flush Mount Sensor,
part # FLUSHSENSOR
Surface Mount Sensor,
part # SENSOR-SMT