Varian 947 Instruction Manual - Draf
DRAF
T 2/4/02
Service Pendant Hand-Held Terminal
4
Example 1 – Set Reject Set Point
Four individual reject set points can be set, but only one reject set point is enabled at a time.
To set a reject set point value and make it the active reject set point:
1. Display (show) the existing reject set point value and see if it is enabled (on or off).
❑
Press
1
(the number of the reject set point you want to display, i.e., 1 though 4)
❑
Press:
The currently enabled set point is displayed along with its value and on or off. On
indicates that the displayed set point is enabled.
2. Set reject set point 1 value to 5.5E
−
5.
NOTE
The pendant will display exponential values to 2 characters.
However, the single digit (in this case 5) or both digits (05) are
valid entries.
❑
Press the following keys in order from left to right to enter the value:
The system displays INIT, followed by the value and ends the string with ok.
3. Enable reject set point 1 (make it the active reject set point).
❑
Press the following keys in order from left to right to enable reject set point 1:
The pendant displays the reject set point, its value and on to indicate reject set point 1 is
enabled.
SET
REJ #
SHOW
5
.
5
E
SHIFT
_
.
5
REJ3
SET
REJ 1
1
SHIFT
SET
REJ #
SHOW