Vax vrs101 Instruction Manual - Filters
12
Actual model may vary from images shown.
FILTERS
Post-Motor Filter:
How to Clean
4.8 Click the button on the base of the vacuum
toward the outside edges to unlock the filter
cartridge.
4.9 Remove the foam filter.
4.10 Hold foam filter under running water to
wash. Wring excess water out of filter. Allow
filter to dry for at least 24 hours before replacing.
4.8
4.9
4.10
4.4
4.11
Shroud and Separator:
How to clean
Remove dirt bin.
4.11 Hold dirt bin by carry handle and press release
button (A) to empty dirt bin.
4.12 Twist umbrella tube counter clockwise and pull out
of dirt bin. Hold over bin and shake free of dirt and
debris.
To replace shroud and separator, insert back into dirt bin,
align slots and twist clockwise until tube locks in place.
4.12
Pre-Motor Filter:
How to Clean
Remove dirt bin.
4.4 Twist dirt bin lid counter clockwise and lift
up to remove.
4.5 Remove filter cartridge from dirt bin.
4.6 Separate foam filter from filter cartridge.
4.7 Hold filter cartridge over rubbish bin and tap
off dirt and debris. The filter can also be cleaned
by running under water to wash.
To replace bin lid line up with lock and twist
clockwise to lock inplace.
4.5
4.6
4.7
To reduce the risk of personal injury - Unplug
before cleaning or servicing.
Do not operate vacuum without either the dirt
bin or filters in place.
A
CAUTION
!
!
To reduce the risk of personal injury - Unplug
before cleaning or servicing.
Do not operate vacuum without either the dirt
bin or filters in place.
CAUTION
!
!
To reduce the risk of personal injury - Unplug before cleaning or
servicing. Do not operate vacuum without either the dirt bin or
filters in place.
CAUTION
!
!