Vax vrs101 Instruction Manual - 4.13
13
4.13
BELT AND BRUSHBAR
How to Replace
4.13 Lay the vacuum flat and flip it to expose the
nozzle base. The base should lay flat and face up.
Remove the five screws.
4.14 Pull and lift the nozzle guard off.
4.15 Lift and remove the brushbar. Dispose of the
old belt.
4.16 Slide belt onto motorshaft.
4.17 Place new belt in area of brushbar without
bristles.
4.18 With new belt in place, pull and slide brushbar
into nozzle making sure that the brushbar end caps
are in the correct orientation. Rotate brushbar
manually to make sure belt is properly aligned.
4.19 Reattach nozzle guard.
4.20 Secure by aligning the three tabs in the
base slots.
4.21 Replace all five screws to secure nozzle guard.
4.14
4.15
SLOTS
TABS
five (5)
4.16
SLOTS
TABS
five (5)
4.17
SLOTS
TABS
five (5)
4.18
SLOTS
TABS
five (5)
4.19
SLOTS
TABS
five (5)
4.20
SLOTS
TABS
five (5)
4.21
CAUTION
!
!
To reduce the risk of injury from moving parts
- Unplug vacuum before servicing.