1. DL manuals
  2. Vega
  3. Measuring Instruments
  4. VEGAPULS 65
  5. Quick Setup Manual

Vega VEGAPULS 65 Quick Setup Manual

Manual is about: Radar sensor for continuous level measurement of liquids

Summary of VEGAPULS 65

  • Page 1

    Quick setup guide radar sensor for continuous level measurement of liquids vegapuls 66 foundation fieldbus document id: 47141.

  • Page 2: Contents

    2 contents vegapuls 66 • foundation fieldbus 47141-en-180226 contents 1 for your safety ......................................................................................................................... 3 1.1 authorised personnel ..................................................................

  • Page 3: 1  For Your Safety

    3 1 for your safety vegapuls 66 • foundation fieldbus 47141-en-180226 1 for your safety 1.1 authorised personnel all operations described in this documentation must be carried out only by trained specialist personnel authorised by the plant operator. During work on and with the device the required p...

  • Page 4

    4 1 for your safety vegapuls 66 • foundation fieldbus 47141-en-180226 depending on the instrument version, the emitting frequencies are in the c, k or w band range. The low emission power is far below the internationally approved limit values. When used correctly, the device poses no danger to healt...

  • Page 5

    5 1 for your safety vegapuls 66 • foundation fieldbus 47141-en-180226 this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: • this device may not cause interference, and • this device must accept any interference, including interference that may ca...

  • Page 6: 2  Product Description

    6 2 product description vegapuls 66 • foundation fieldbus 47141-en-180226 2 product description 2.1 configuration thetypelabelcontainsthemostimportantdataforidentificationand use of the instrument: 2 1 15 13 14 12 11 5 3 6 4 7 8 10 9 fig. 1: layout of the type label (example) 1 instrument type 2 pro...

  • Page 7

    7 2 product description vegapuls 66 • foundation fieldbus 47141-en-180226 this operating instructions manual applies to the following instrument versions: • hardware from 2.1.1 • software from 4.5.0 scope of this operating instructions manual.

  • Page 8: 3 Mounting

    8 3 mounting vegapuls 66 • foundation fieldbus 47141-en-180226 3 mounting 3.1 mounting instructions 1. Distance from the vessel wall > 200 mm, the antenna should protrude > 10 mm into the vessel > 500 mm (19.69") ca. 10 mm fig. 2: distance of the antenna to the vessel wall/vessel ceiling 2. Note min...

  • Page 9

    9 4 connecting to the bus system vegapuls 66 • foundation fieldbus 47141-en-180226 4 connecting to the bus system 4.1 connecting the voltage supply and signal output are connected via the spring- loaded terminals in the housing. Connection to the display and adjustment module or to the interface ada...

  • Page 10

    10 4 connecting to the bus system vegapuls 66 • foundation fieldbus 47141-en-180226 8. Connect the screen to the internal ground terminal, connect the externalgroundterminaltopotentialequalisation 9. Tighten the compression nut of the cable entry gland. The seal ring must completely encircle the cab...

  • Page 11: Module

    11 5 set up with the display and adjustment module vegapuls 66 • foundation fieldbus 47141-en-180226 5 set up with the display and adjustment module 5.1 insert display and adjustment module the display and adjustment module can be inserted into the sensor andremovedagainatanytime.Youcanchooseanyoneo...

  • Page 12

    12 5 set up with the display and adjustment module vegapuls 66 • foundation fieldbus 47141-en-180226 1 2 fig. 7: installing the display and adjustment module in the double chamber housing 1 in the electronics compartment 2 in the terminal compartment note: ifyouintendtoretrofittheinstrumentwithadisp...

  • Page 13

    13 5 set up with the display and adjustment module vegapuls 66 • foundation fieldbus 47141-en-180226 the radar sensor measures the distance from the sensor to the product surface. For indication of the real level, an allocation of the measured distance to the percentage height must be carried out. 1...

  • Page 14

    14 5 set up with the display and adjustment module vegapuls 66 • foundation fieldbus 47141-en-180226 thefollowingcircumstancescauseinterferingreflectionsandcan influencethemeasurement: • high mounting sockets • vessel internals such as struts • agitators • buildup or welded joints on vessel walls no...

  • Page 15

    15 5 set up with the display and adjustment module vegapuls 66 • foundation fieldbus 47141-en-180226 too high a level and not all false signals could be detected. When selecting "extend", the distance to the product surface of the created false signal suppression is displayed. This value can now be ...

  • Page 16

    16 5 set up with the display and adjustment module vegapuls 66 • foundation fieldbus 47141-en-180226 menu item parameter default setting simulation percent curve indication echo curve - false signal sup- pression - echo curve memory - menu item default setting instrument units distance in m temperat...

  • Page 17: 6 Supplement

    17 6 supplement vegapuls 66 • foundation fieldbus 47141-en-180226 6 supplement 6.1 technical data note for approved instruments the technical data in the respective safety instructions are valid for approved instruments (e.G. With exapproval).Thesedatacandifferfromthedatalistedherein,forexampleregar...

  • Page 18

    18 notes vegapuls 66 • foundation fieldbus 47141-en-180226.

  • Page 19

    19 notes vegapuls 66 • foundation fieldbus 47141-en-180226.

  • Page 20

    Printing date: vega grieshaber kg am hohenstein 113 77761 schiltach germany 47141-en-180226 all statements concerning scope of delivery, application, practical use and operat- ing conditions of the sensors and processing systems correspond to the information available at the time of printing. Subjec...