Vent-Axia Sentinel User, Installation & Maintenance Manual - page 12
Installation
12
Sentinel Kinetic MVHR with Cooker Hood Installation & Commissioning
5.
Replace the “L” shaped duct front cover and
tighten the three screws
Wall Mounting
6.
A wall mounting template can be obtained from
Vent Axia technical support or refer to pages 8
& 9 for dimensions.
7.
If you are in receipt of wall mounting template,
fix the template to the wall and ensure that it is
level.
8.
Mark the position of the condensate outlet and
the four upper and four lower fixing holes.
9.
See page 8 & 9. To install the condensate
outlet refer to Sentinel Kinetic Installation &
Commissioning document page 11.
10. Drill and plug the wall at the fixing points.
11. Locate the bottom supporting bracket provided
then use four screws to fix to the wall. Ensure
the angled flange is pointing towards you.
12. The upper four screws should now be fitted
ready for keyhole fixing slots to engage. Leave
6 – 10 mm protruding.
13. Lift the unit and offer it to the upper screws
sliding downwards, making sure that the lower
part of the back plate of the unit fits into the
lower supporting bracket.
14. Complete the fixing of the condensate drain as
shown on page 11 of the Sentinel Kinetic
manual.
15. Fix hanging brackets supplied to the front door
panel, then offer it to the pre-fitted bushes.
Spacers may be used to pack out the bushes to
maintain the line of the cupboard doors.