Venus Splash digital User Manual - Glass Lined
6
GLASS LINED
WATER HEATER
B. Using the heater regularly :
1.
Always keep the inlet valve open so that water drawn from the hot wa-
ter tap is automatically replace from the mains.
2.
Switch “ON” the Heater. The Red color indicator will glow, indicating that
the heater is working.
3.
When the water reaches the required temperature the thermostat will
switch “OFF” the power automatically. The approximate time taken to
switch “OFF” by the thermostat for different capacities is give in “Perfor-
mance Table ” on Page no-8
4.
In general, assuming a room temperature of 20°C it will take 12hours for
the water temperature to drop from 65°C (Very Hot) to 40°C(Warm)
5.
The Thermostat setting may be changed by the user to suit own choice.
Lowering the setting of the thermostat will give a lower hot water tem-
perature increasing the setting will give a higher output temperature.
6.
Initially it may take a long time for the water to get hot, So switch “ON” the
water heater at least an hour before you want use it,
7.
If you require hot water early in the morning the heater can be switched
“ON” the previous night itself. The thermostat will switch “OFF” the power,
When the water reaches the set temperature.
8.
The heater can also be kept “ON” always, if required, Since the heater is
completely insulated, the water will remain hot. The thermostat will switch
“ON” and “OFF” automatically to keep the water at a constant temperature
in the way you can always get hot water at the turn of the tap.
C. Operation in Hard Water areas
1.
In hard water areas, a hard salt deposit (scale) forms on surfaces in contact
with water. The scale formed on the heating element reduces the heat
transmission and causes early failure of the element.
2.
Scale formation can be reduced by operating the water heater at a
temperature lower than, 50ºC. This can be done by resetting the tempera-
ture to 50ºC or below.
CAUTION
The thermostat is a sensitive device and should not be adjusted
frequently in order to maintain its correct functioning.