Verdant V8-BB-7S Instruction Manual - page 11
- 20 -
- 21 -
USING THE THERMOSTAT
Energy-Saving Occupancy Detection
...if the room becomes unoccupied
If the room is unoccupied for 15 minutes, the
thermostat will automatically reduce the
temperature setpoint to 70° (72° - 2°).
Occupancy Detection Example
If the temperature setpoint is 72°F and the
occupancy settings are the same as the
examples shown on previous pages:
Short Vacancy Setting
If unoccupied 15 minutes
Reduce Temperature by 2;
Long Vacancy Setting
If Unoccupied 2 Hours
Reduce Temperature to 64;
Then the following will happen...
USING THE THERMOSTAT
Energy-Saving Occupancy Detection
...when occupancy is detected
If at any point occupancy is detected, the
thermostat will automatically restore the
temperature setpoint to the original value (in this
example 72°)
NOTE: If the thermostat is in the AUTO
temperature control mode, the thermostat
will reset occupancy timers and restore
temperature to the temperature setpoint
programmed for the event every time the new
event starts.
When occupancy is detected, the thermostat
will flash the “unoccupied” temperature
five (5) times and then flash the restored
temperature five (5) times to indicate the
setpoint change.
...if the room remains unoccupied
If the room is unoccupied for 2 hours, the
thermostat will automatically reduce the
temperature setpoint to 64°.