Verdant V8-BB-7S Instruction Manual - page 5
- 8 -
- 9 -
CONFIGURATION
Thermostat Modes
Changing the Thermostat Mode
To switch between “Programmable” and “Non-
programmable” thermostat mode:
Press and hold the Program button [
] and
the Home/Mode button [
] for four (4)
seconds until the thermostat mode changes.
Energy-saving occupancy detection is
available in both “Programmable” and “Non-
programmable” thermostat mode.
Thermostat Modes Description
Verdant thermostat can be used as a 7-day
programmable thermostat or a simple-to-use
non-programmable thermostat.
Programmable thermostat mode allows
pre-programming up to four (4) automatic
temperature changes (events) for each day of
the week.
Non-programmable thermostat mode allows
turning the thermostat into a simple-to-use
thermostat with only basic temperature
control options.
Changing the Equipment Mode
To switch between “Radiant” and “Fan Forced”
equipment modes:
Press and hold the
Program button [
].
While holding the
Program button [
],
press the Time Back
button [
].
Equipment Modes Description
Verdant thermostat has two (2) distinctive
equipment modes for operating different
kinds of heating equipment.
Select the “Radiant” operation mode if you are
using the thermostat to control an electric
baseboard or radiant heater.
Select the “Fan Forced” operation mode if you
are using the thermostat to control a convector
heater with a built-in fan.
CONFIGURATION
Equipment Modes
In the “Programmable”
mode, the thermostat
displays time and day
information.
In the “Non-programmable”
mode, the thermostat does
not display time and day
information.
In the “Fan Forced” mode,
the animated fan indicator
shows the fan activity.
In the “Radiant”
mode, a power-meter
proportionally shows
power consumption.