VoiceInterop AudioMate AM360r User Manual - Quick Start Guide
www.VoiceInterop.com
8000 N. Federal Highway, Suite 100, Boca Raton, FL, 33487 V: +1 561.939.3300
AM360r User Manual
revised 2009.05.25 for
Hardware Rev. B
Firmware Version 1.00.24
Quick Start Guide
Gather Your Tools
Web browser — Mozilla Firefox, Opera, Chrome, or Internet Explorer.
AM360 Configuration Utility — To find the address of each AM360 gateway, download the
AudioMate 360 IP Setup utility from our web site, www.voiceinterop.com under the Support
tab. You must first register as an owner of an AudioMate 360 gateway to be granted access.
(Optional) Telnet client — comes with Windows, or you can use a third-party client.
(Optional) USB Comm Port Driver — To view the boot and debug messages and set
passwords you will need the USB comm port driver set from FTDI. These are quite common
in many products so you might already have them installed.
(Optional) USB A to USB-mini B cable — To connect from your computer to the AM360 serial
port
(Optional) Terminal program — HyperTerminal comes with Windows, or you can use a third-
party datacomm terminal.
NO soldering iron nor screwdriver is needed to set up the gateway, just a web browser and a
plan.
Basic Configuration Steps
Find the IP address
Log in
Set the RTP address and ports
Check for proper control signals and logic levels on the radio interface
Set audio levels with a partner
Find the AudioMate 360 IP Address
Use the AM360 (AudioMate 360) Configuration Utility to find the IP address that was
assigned by your DHCP server. Click the
Locate
button and select a unit from the list on the
left pane.
Log In to the AudioMate Unit with a Web Browser
Type the IP address of the desired unit from the list displayed by the AM360 Configuration
Utility into the address bar of your web browser and press Enter. The AM360 will prompt you
for the user name and password. The factory values are
admin and password.
Set the RTP Address and Ports
The default AM360 settings might be all that you need to get going. If necessary, set the
Remote RTP Address, RTP Remote Port, and RTP Local Port to communicate with your audio
network.
Check Control Signals
Ensure that the proper cable is connected between the AM360 and the radio. Set the COS
Polarity and PTT Polarity to match the needs of the radio. Check that the AM360 is able to
key the radio transmitter and that the radio is programmed to provide COR/COS/RUS/receive
activity indicator on the proper wire.
¤
¤
¤
¤
¤
AM360 Configuration
Utility
www.voiceinterop.com
Register as a customer
Choose the Support tab.
Download AudioMate 360 IP
Setup configuration utility
AM360 Configuration
Utility
www.voiceinterop.com
Register as a customer
Choose the Support tab.
Download AudioMate 360 IP
Setup configuration utility