VoiceInterop AudioMate AM360r User Manual - Configuration
www.VoiceInterop.com
8000 N. Federal Highway, Suite 100, Boca Raton, FL, 33487 V: +1 561.939.3300
AM360r User Manual
revised 2009.05.25 for
Hardware Rev. B
Firmware Version 1.00.24
Configuration
Each unit requires two groups of configuration data: one group that is common across the
AudioMate 360 family and a second group that is specific to the application of the unit.
Network Address
The units are shipped with DHCP enabled and will accept whatever address is assigned
by your DHCP server. On startup the AM360 will wait up to 60 seconds for a DHCP server
to assign its IP address. On timeout the AM360 will assign itself a default IP address of
192.168.0.254 and a netmask of 255.255.255.0.
Locating the AM360 Address
Use the AudioMate 360 Configuration utility to locate the addresses of your units in
preparation for configuration. Individual AudioMate 360 units are configured via web
browser pointed to the unicast management IP address of the unit. The Address Finder
utility is available by logging in to our web site
www.voiceinterop.com
Click the Support tab to find the link to download the AM360 Configuration Utility.
Open the AM360 Configuration Utility and click the
Locate
button and select a unit from the
list on the left pane. The IP address of each unit is to the right of each minus sign.
Configuring by Web Browser
Type the address of the desired AM360 unit into the address bar of your web browser. (At
the time of this writing the freely available Mozilla Firefox web browser provides smoother
operation for these purposes.)
Logging In
Like most network devices, the AM360 is protected by a password. The factory default for
user name is
admin and the factory default password is password.
When prompted by the web interface enter the appropriate user name and password. If they
were accepted you will see a two part screen with a menu panel on the left pane and a page
labeled
AM360 Status
on the right pane.
Global Configuration
In the menu pane on the left, locate the
Configuration
heading and click the link
Global
under it. The screen labeled
AM360 Configuration
should appear in the right pane.
You may safely ignore the
AMCP
settings. Please.
This Unit’s Name
allows you to set a memorable name to identify this unit among the others
on your network. This field accepts standard alphanumeric characters.
Boot IP Mode
selects between automatic IP address assignment by your DHCP server or
static IP address assignment specified in the fields that follow. If you select Static IP and
then click the
Update Unit
button, the
IP Boot
fields will be filled with current values. If
you select DHCP and click the
Update Unit
button the fields will be returned to 0.0.0.0
which indicates DHCP. Note that editing and saving the Boot IP fields has no effect on
communications until you reboot the unit.
config
config
AM360 Config Utility
The Address Finder utility is
available by logging in to our
web site:
www.voiceinterop.com
Click the Support tab.
AM360 Config Utility
The Address Finder utility is
available by logging in to our
web site:
www.voiceinterop.com
Click the Support tab.
AudioMate 360 Login
username = admin
password = password
AudioMate 360 Login
username = admin
password = password