VoiceInterop AudioMate AM360r User Manual - page 8
www.VoiceInterop.com
8000 N. Federal Highway, Suite 100, Boca Raton, FL, 33487 V: +1 561.939.3300
AM360r User Manual
revised 2009.05.25 for
Hardware Rev. B
Firmware Version 1.00.24
Boot IP Addr
sets the static unicast management IP address used to configure this unit.
Default is 0.0.0.0 for DHCP. Once you change this address, set the mask, update and reboot
the unit, remember to point your web browser to the newly assigned address.
Boot IP Mask
sets the netmask or network portion of the IP address. In a typical Class C
network this will be 255.255.255.0 while the default value is 0.0.0.0 for DHCP use. If you set a
static IP address you must also set this field to represent the size of your network.
Boot IP Gateway
sets the default network gateway router that will carry your packets to
other networks. If you set a static IP address you must also set the gateway to the default
router on your network. The default value is 0.0.0.0 for DHCP use.
Boot IP DNS
sets the IP address of your DNS server, if needed. Typically this address will be
the same as your default gateway in small networks. Default is 0.0.0.0 for DHCP use.
AMCP Configuration
You may safely ignore the AMCP settings.
RTP Configuration
RTP Remote IP
is the address to which audio packets will be sent. In multicast networks
type the multicast group which will share audio with other units on the same multicast
group. The Class D multicast range lies between
225.0.0.0 and 239.255.255.255
with numerous restrictions and considerations. Consult Appendix B for more information
on multicast address assignment. For point-to-point unicast links type the unicast address
(Boot IP Address) of the other end of the link, not this unit. A unicast address set here
should fall within your network’s private IP address space. Default is 239.1.1.1 multicast
group.
RTP Remote Port
is the IP port number assigned to this channel. This should be an even
number between
16384 and 65534. Default is 18000.
Boot IP Addr
After changing the IP address
of the AM360r you must
reboot the unit to make the
new IP address effective.
Also remember to change
the address in your browser!
Boot IP Addr
After changing the IP address
of the AM360r you must
reboot the unit to make the
new IP address effective.
Also remember to change
the address in your browser!
Multicast Addressing
Appendix B has more detail
on selecting multicast
addresses with pointers to
reference sources.
Multicast Addressing
Appendix B has more detail
on selecting multicast
addresses with pointers to
reference sources.
RTP Remote IP
is the address of other unit
if using unicast, not the one
that you are configuring.
RTP Remote IP
is the address of other unit
if using unicast, not the one
that you are configuring.