VoiceInterop AudioMate AM360r User Manual - page 22
www.VoiceInterop.com
8000 N. Federal Highway, Suite 100, Boca Raton, FL, 33487 V: +1 561.939.3300
AM360r User Manual
revised 2009.05.25 for
Hardware Rev. B
Firmware Version 1.00.24
Under Configuration click
Global
.
In the field
RTP Remote IP
type the unicast address of the target media server. For
RTP
Remote Port
and
RTP Local Port
type a port number between
16384 and 65534; both
fields should be identical numbers. For
Codec
select G.711u; if your network will not support
about 100kbps streams then select GSM. Click the button
Update Configuration
to save
your changes.
WAVE
C
hannels
(WaVe 3)
Log in to WAVE. Click
Channels
->
Channels
, then click the
Add Channel
button. From the
dropdown listbox select Point-to-point Trunk, then click the
Next
button. In the
Name
field
type a meaningful name. Tab to the
Description
field and type a meaningful description.
Select a group from the
Group
listbox.
In the
Trunk Side A IP address
field type the IP address of the target media server. In the
Port
field type the same port number that you configured into the AM360 above.
In the
Trunk Side B IP address
field type the IP address of the AM360 above. Tab over to the
Port
field and type the exact same port number that you configured into the AM360 above.
In the
Codec
listbox select the same codec as was selected in the AM360 above; if you
choose GSM then set the Scale to 1. All remaining settings may be left at their defaults.
Click the
Save
button to save your changes. If there are no other configuration changes to
be entered, click the button
Commit Changes
; else, configure Sessions as above.
C
hannels
(WaVe 4)
Log in to WAVE. Click
Media Servers
->
Interfaces
, then click the
Add Interface
button.
From the dropdown listbox select VoiceInterop AM360 and click the
Next
button. In the
Name
field type a meaningful name. Tab to the
Description
field and type a meaningful
description.
In the
Gateway IP Address
field type the management address of the AM360 that will be
associated with this endpoint. In the
RTP Remote IP address
field type the management IP
address of the AM360 above. Tab over to the
RTP Remote Port
field and type the exact same
port number that you configured into the AM360’s field labeled ‘RTP Local Port’. Leave the
RTP Local IP address
field blank to use the binding IP address of the target media server. Tab
over to the
RTP Local Port
field and type the exact same port number that you configured
into the AM360’s field labeled ‘RTP Remote Port’.
In the
Codec
listbox select the same codec as was selected in the AM360 above; if you
choose GSM then set the
Scale
to 1.
Click the
Save
button to save your changes. If there are no other configuration changes to
be entered, click the button
Commit Changes
.
The session that bridges these unicast channels is configured in a procedure similar to
bridging multicast channels in WAVE version 4.
Remote vs Local
The terms Remote and Local
are relative to the device that
you are configuring. In WAVE,
the media server is the Local
address while Remote refers
to the AudioMate 360 unit.
Remote vs Local
The terms Remote and Local
are relative to the device that
you are configuring. In WAVE,
the media server is the Local
address while Remote refers
to the AudioMate 360 unit.
This document is copyright © 2008 by VoiceInterop, Boca Raton, Florida, U.S.A.
All rights reserved.