VoiceInterop AudioMate AM360r User Manual - page 21
www.VoiceInterop.com
8000 N. Federal Highway, Suite 100, Boca Raton, FL, 33487 V: +1 561.939.3300
AM360r User Manual
revised 2009.05.25 for
Hardware Rev. B
Firmware Version 1.00.24
C
hannels
(WaVe 4)
Log in to WAVE. Click
Media Servers
->
Interfaces
, then click the
Add Interface
button.
From the dropdown listbox select VoiceInterop AM360 and click the
Next
button. In the
Name
field type a meaningful name. Tab to the
Description
field and type a meaningful
description.
In the
Gateway IP Address
field type the management address of the AM360 that will be
associated with this endpoint. In the
RTP Remote IP address
field type the exact same
multicast group address that you configured into the AM360 above. Tab over to the
RTP
Remote Port
field and type the exact same port number that you configured into the AM360
above. In the
RTP Local IP address
field type the exact same multicast group address that
you configured into the AM360 above. Tab over to the
RTP Local Port
field and type the
exact same port number that you configured into the AM360 above.
In the
Codec
listbox select the same codec as was selected in the AM360 above; if you
choose GSM then set the
Scale
to 1.
Click the
Save
button to save your changes. If there are no other configuration changes to
be entered, click the button
Commit Changes
.
s
essions
(WaVe 3)
If you already have the desired standard user channel configured, click
Sessions
->
Sessions
,
then click the
Add Session
button.
In the dropdown listbox select
Advanced
, then click the
Next
button.
Type a meaningful name in the
Name
field. Tab to the
Description
field and type a
meaningful name. Select the desired group from the
Group
listbox and click the
Save
button to reveal the full Session configuration screen.
Leave the
Conference ID / DN
field blank and clear the checkbox labeled
Treat as the Dial-In
DN
. Click the
Add Servers
button and select the desired media servers that will handle this
session. Click the
Add Participant
button and add the multicast trunk channel from above
and the desired standard user channel that will be bridged with this AM360 device.
Click the button
Save and Commit changes
. Your AudioMate 360 device is now bridged
via multicast with the desired WAVE Standard channel. Test the configuration using an
AudioMate Communicator soft console.
s
essions
(WaVe 4)
To configure a session in WAVE version 4, proceed as directed for WAVE 3 installations. The
only difference comes when adding participants to the session. After adding the standard
user channel as indicated for WAVE 3, click the
Add Participant
button again. In the
dropdown listbox select VoiceInterop AM360, then click the
Next
button. Select the desired
AM360 by checking the box next to it, then click the
Add Selected Participants
button.
Unicast Configuration
AM360
Open a web browser and point it to the management IP address of the AudioMate
360 device to be configured. Log in with user
admin and password password or the
credentials that you have configured.
WAVE 4
The AudioMate 360 is
integrated into WAVE 4 as a
media server interface. Add
an AM360 to a session as an
interface.
WAVE 4
The AudioMate 360 is
integrated into WAVE 4 as a
media server interface. Add
an AM360 to a session as an
interface.