VolantexRC ASW28 Instructions Manual - Control / Servo Reversing

Low Battery Voltage/Power Indication

When the  AA  battery voltage / power  drops to a level that’s too low for safe co-

ntinued  operation ,  the  red color LED indicator will begin flashing. DO NOT use  

the transmitter or fly when the red LED indicator is flashing and immediately insta-

ll new AA batteries before using the transmitter or flying.

Control / Servo Reversing

The transmitter features control/ servo reversing functionality  for the  aileron, ele-

vator, throttle and rudder channels. The control / servo  directions were set correctly 

at the  factory for  the plane , however , in  case  the  controls are operating in the  

wrong direction , or you use the  electronics in other  models later on, simply  change 

the position of ‘Servo Reverse’ switch for the channel(s) as needed.

 Thoroughly 

check that the controls are operating in the correct sense BEFORE you fly.

Delta / Elevon Mixing

Located to the right of the ‘Servo Reverse’ switches is a switch that activates / de-

activates the optional-use  ‘Delta / Elevon’ mixing. No such mixing is used for th

is

model

 so please be sure  this switch is in the OFF / lower position ( failure to do 

so will result  in improper control and the  inability to fly  the plane ). However, if 

using this transmitter with  ‘flying wing’ , delta or other airplanes that  ‘combine 

(mix)’ the elevator and aileron (often known as ‘elevon’) controls you can move the 

switch to the ON/upper position.

13

Elevator

  (↑↓)

ON

(↑↓)

Motor trimmer

(← →) Rudder

Rudder  trimmer

Aileron trimmer

Aileron

Rudder

Commingle control switch (it can 

realize the mode transform of “V”

model triangle wing).The CH1 

controls with the Ch2 passage mix

Motor

E levator 

Aileron (← →)

Mode 2  (Right throttle)

Motor 

Motor trimmer