VolantexRC ASW28 Instructions Manual - Rudder Not
NOTE: You should always rotate the clevis until the pin is perpendicular with
the control horn to ensure the pin is not under any excessive load/ pressure
when inserted in the hole and during operation. In some cases it may not be
possible to ‘exactly’ center the surface mechanically while properly aligning the
pin. In these cases be sure the pin is properly aligned then adjust the position
of the trim lever slightly as needed. Also, it will likely be necessary to make
After connecting the clevises to the control horns view the vertical tail and rud-
der from directly above. The rudder should be ‘ in line ’ with the vertical tail
when it’s properly ‘centered’. However, if the rudder is angled off to the right or
left you can adjust the length/position of the pushrod/clevis so the surface
is centered ‘mechanically’ while the trim lever on the transmitter is centered.
If the rudder is angled off to the left carefully remove the clevis from the control
horn and screw it ‘in’(clockwise) one half to one full turn then insert the pin back
into the outermost hole in the control horn. Or, if the rudder is angled off to the
right carefully remove the clevis from the control horn and screw it ‘out’ (coun-
ter-clockwise) one half to one full turn then insert the pin back into the outer-
most hole in the control horn.
View the vertical tail and rudder from directly above again and continue adju-
sting the length/position of the pushrod/ clevis until the rudder is centered ap-
propriately.
Rudder NOT
properly centered
Rudder properly
centered
7