Vollara LAUNDRY PURE User Manual - page 11
11
When connecting hoses to your
LaundryPure hand start the hose
connector(s) Using adjustable
pliers finish tightening hose
connector(s).
CAUTION:
Some washing machine models require water to flow through both the
HOT and COLD valves for proper operation. In some cases, if only the
COLD water side is connected, the water valve will not operate or the
washing machine will not fill to the proper level. To solve this problem,
the installation of a “Y” adaptor (available at most hardware stores)
may be used. The use of the “Y” adaptor allows water to flow equally
through both the HOT and COLD water valves. Optional stainless steel
hose (US70980) must be installed on the hot water connection. To
Install, turn water off at the valves and disconnect the existing HOT
water hose (at the valve and washing machine) Connect the “Y” adaptor
to the Outlet on your LaundryPure, then connect both the optional
stainless steel hose (US70980) and Cold hose from your washer to the
“Y” adaptor (see diagram below). Operate your washer on the WARM/
WARM setting (your LaundryPure will still be
using just cold water).
Turn off both water valves (hot and
cold) before disconnecting hoses.
Failure to follow these instructions may
result in water leakage and/or possible
injury from hot water.
CAUTION:
NOTE:
Your hot source water
valve will not have a hose
connected to it. Make sure it is
fully turned off. It is recommended
you secure a cap (available at
most home improvement stores)
to prevent leakage.
FOR WASHERS THAT REQUIRE HOT & COLD WATER INPUT
Connect to household
plumbing COLD water valve
“Y” adaptor
Make sure the “Y” adaptor
valve is in the on position.
Connect to HOT water inlet on
washing machine
Connect to COLD water inlet
on washing machine
Disconnect the existing hose
from the HOT valve and
washing machine and
remove. Replace with
optional stainless
steel hose.
Part No. US70980
(not included).
Disconnect this
stainless steel hose
from the OUTLET on
your LaundryPure,
then connect
it to the “Y”
adaptor.
Connect the “Y” adaptor to the
OUTLET on your LaundryPure.
Be sure to hold the fitting with
pliers while tightening the
adaptor.
Stainless steel hose supplied
with LaundryPure.