Vollara LAUNDRY PURE User Manual - page 6
6
This appliance must be installed in a level,
horizontal configuration as shown.
Do not
install the unit vertically, below the top of
the washer or at an angle. Failure to follow
these instructions may prevent the internal
moisture sensor from operating properly.
CAUTION:
INSTALLATION OF WALL ANCHORS OR SCREWS
A. If using supplied wall anchors, drill two 3/16” diameter
holes. Place two wall anchors into the wall. Install two
supplied screws and tighten until almost all the way in.
B. If mounting to wall studs, drill two 3/32” diameter
holes approximately 1” deep. Install two supplied
screws and tighten until almost all the way in.
16” OC
Keyholes
NOTE: Washing machine and cold water faucet must
be within 4 feet of the right side of unit.
1
Level and place the LaundryPure to the wall and mark
where the two (2) keyholes are on each side with a pencil.
Screws (not shown)
2
Position the keyholes of the LaundryPure onto the screws
(not shown). Finish tightening screws enough to securely
mount unit, but still allowing it to be removed from wall.
Remove unit from wall.