Volth S-NET1 Operation manual - page 14
Connect a network cable to “RJ45 MAIN” port, (the cable should be more than 10m). choose
“Length”---“CAT5”---“Calibration” to start to adjust the length value, press to add , to
reduce the value, when adjust the value into actual length value, press OK to save the data.
The details is as below
The method of cable length test for parameter callout: eg: Network cable as Due to different
technical parameters with different branded cables, We recommend users to calibrate a
given-length cable before measuring length (Refer to the related chapter for more details.).
After entering main menu, move the cursor button to Cable length test. Then
press OK; at this time, choose network cable, press OK, and choose “Load Data” , press OK
to choose the data saved.
Data export: eg: Network cable
When you want to export the data you saved before, enter “ Length”---“CAT5”---“Data export”,
choose the desired data to export, the screen will display as below, which means the data has
been exported to TF card.
Length
RJ11
BNC
CAT5
CAT6
CAT5 Calibration
Calibration
Unit:Meter
Data export
Load Data
Length
Tseting...
13.3Meter
13.7Meter
Calibration 1
Calibration 2
Calibration 3
Calibration 4
Calibration 5
Calibration 6
Calibration 7
Calibration 8
Calibration 9
Return
Saving...
CAT5 Calibration
CAT5 Calibration
CAT5 Calibration
CAT5 Calibration Save
CAT5 Calibration Save
press once,+ 0.1m
press once,-0.1m
long press to set the data quickly
press "ok "to store the data
Mapping
Port Flash
POE
Scan
Menu
Length
Ping
Load!
CAT5 Length
Calibration
Unit:Meter
Data export
Load Data
Length
CAT5 Load Data
Calibration 1
Calibration 2
Calibration 3
Calibration 4
Calibration 5
Calibration 6
Calibration 7
Calibration 8
Calibration 9
Return
CAT5 Load Data
Length
RJ11
BNC
CAT5
CAT6
Mapping
Port Flash
POE
Scan
Menu
Length
Ping
Data saved to:LONGRJ45.TXT
CAT5 Data Upload
CAT5 Length
Calibration
Unit:Meter
Data export
Load Data
Length
Length
RJ11
BNC
CAT5
CAT6
Mapping
Port Flash
POE
Scan
Menu
Length
Ping