Volth S-NET1 Operation manual - page 15

d. Cable scanning (POE router & other brand router) NF-8601A doesn’t)

After entering main menu, choose icon”scan” and press OK to enter, then press Up/ Down 

button to switch scan modes. Choose “ scanning” mode if scan cable on ordinary switch(graph 

No.2), choose “scanning PoE switch” if scan cable on PoE switch (graph No.3). 

Caution: users must choose POE switch mode if trace network cables on PoE Switch.

Usage of Receiver         this button on the receiver , when you open the device, and      

lighting , that means  works normally , Press button “SET” to change the working mode: 

scanning cable/ voltage detecing. In scan mode, the scan indicator will be lighten, when you 

scan cable, you can take the receiver get close to the tested cables , when it finds the target 

cable , it will generate “Beep” , and at the same time , the “scan” indicator will flash when in 

voltage detecting mode, NCV indicator will be lighten Take receiver to get closed to the socket 

where exsits voltage ,when it will generate sound, which  means AC voltage presence.

              button on the receiver used to control lighting and detect currency ;           button is 

sensitivity control when you find the cables. The receiver charge : when connected the 

receiver charge , The light will shining near the MICRO , and the same time , the charge 

Indicator light will flashing , after full of power , this light will always lit.

1. Tracing cable (RJ45/RJ11 Cable) which is connected to switch or router. Insert the 

cable into port RJ11/ RJ45 (S), turn on the receiver, the led “ power” will be lit, then press 

“SET” button, the led "scan" is lit., then hold the receiver close to the cables, when the probe 

gets close to the targeted one, you can hear clear and loud “beep,beep, beep” .

(Note: telephone cable into RJ11, Lan cable into port RJ45 Scan)

Note: in this case, users should alter the voice to degree 1~2 in order to find out  targeted 

cable precisely.

2. Tracing Coax cable Insert the cable into port BNC, turn on the receiver, the led “ power” 

will be lit, then press “SET” button, the led “scan” is lit ., then hold the receiver close to the 

cables, when the probe gets close to the targeted one, you can hear clear and loud 

“beep,beep, beep” . 

Mapping

Port Flash

POE

Scan

Menu

Length

Ping

Scan 

Scanning...

Scan 

Scanning...

--POE switch--