Volth S-NET1 Operation manual - page 18
Parameter specification of PING functions IP address: can obtain automatically any
Internet device which has connected in the global. (Under a specific situation, users need to
manually set IP address when can't be automatically obtain IP address.) Local IP address:It
can be set up,but it must be different with other LAN devices. Default gateway / Router: In the
local LAN Router or gateway IP address. Subnet mask: In the local LAN Subnet mask.
Remark :Default gateway or Router or Subnet mask can be found by the same LAN internet;
Default gateway/ router/ Subnet mask can be found by computer in the same LAN Internet.
The method : Start—Run—input “ CMD”, start up the command programme, then input
“ipconfig” to check out.
Data packet: can be set based on needs.
Usage :
1. LAN communication testing Set the destination IP to the IP of any computer in the same
Lan, this method can check whether the communication is normal in the Lan.
2. Extranet communication testing Set the destination IP address to any IP of extranet, such
as 180.97.33.108 (Baidu), this method can test whether the communication is normal between
intranet and extranet.
Instruction of test results:
The host will send 4 sets of 32-byte data packet to target device for each testing.
Time: it is the round trip time for the communication from the host to target device, which can
identify whether the communication is steady. When it is 1ms, which means it is very steady.
TTL: it is the number of routers or gateways which the 27. communication goes through. When
go through each router or gateway, the TTL No. will reduce one, which can indicate the
Network's topology structure. When TTL=64, it indicates the host and target device connects
directly, without any router or gateway.
h. System set :
When moving cursor “ to “Setup” item, press “OK” key . Move the cursor “ ”
to the relative test . The following interface will be shown:
1. Backlight: enter the “Set” function in main menu, you can set up the backlight brightness
according to your needs: level1, level2, and level3.
2. Backlight time: enter the “Set” function in main menu, you can adjust the backlight time
according to your needs: 15s, 30s,1min.
3. Auto OFF: enter the “Set” function in main menu, you can adjust the auto-off time according
Ping
Ping
Configure
Configure
Ba s e Se t t in g :
Lac a l I
P : 19 2 . 1 68 . 0 . 1 0 7
De f au l t Ro u te r : 192 . 1 6 8 . 0. 1
Su b n e t M a sk : 25 5. 2 55 .2 5 5 . 0
I C MP Pa ck e t S et t in g :
Pa c k et Si ze : 32 by t e s
Ti me Ou t : 200 0 ms
TT L : 64
Am oun t : 4
Au t o - ob t a i n
Configure
L a ca l IP : 1 9 2 . 1 68 . 0 . 1 0
D e f au l t R o ut e r : 1 92 .1 6 8. 0. 1
S u bn et Ma sk : 255 .2 5 5 . 25 5. 0
Mapping
Port Flash
POE
Scan
Menu
Length
Ping
Set
Backlight: Level 3
Light time: 15s
Auto OFF: 15min
Systerm theme: Blue
Data export
Systerm information
Return
Mapping
Port Flash
POE
Scan
Menu
Length
Ping
Set
Menu