Volvo 164 Owner's Manual - page 18
Manuel safety belts
I f the belt requires lengthening, first slacken
the upper section of the belt and take hold
of the adjusting piece with one hand and
pull out the lap strap to the desired length.
Tidy up belt slackness by pulling in the
upper part of the double section.
I f the belt requires shortening, pull in the
upper part of the lap strap's double section.
After a certain amount of practice, all ad-
justments can be carried out with the one
hand. The belt is released by depressing
the red button.
Safety belts in rear seat
As standard, the rear seat is fitted with
anchorages for safety belts.
Servicing
Hang up the belt in the place intended.
Check to make sure that the belt is not
clamped or frays against sharp edges.
Now and again check to make sure that
the anchorage bolts are well tightened and
that the belt is otherwise in good condition.
OPERATING INSTRUCTIONS
Use water and an approved synthetic deter-
gent for cleaning the belts. If a belt is ex-
posed to violent stretching, for example, in
connection with a collision, it should be
replaced even though it may appear to be
undamaged. Also replace a belt if well worn
or damaged.
Never modify or repair a belt on your own,
but have this done by a Volvo workshop.
1 7