Volvo 164 Owner's Manual - page 51
SERVICING
Replacement of bulbs
The replacement of bulbs in the various
li ghting units is shown on the following
pages.
Make sure when fitting bulbs that
the guide pin on the bulb fits into its
corresponding socket.
When fitting bulbs, do not touch the globe
with your fingers. The reason for this is
that grease, oil or any other impurities can
carbonize on the bulb and damage the re-
flector.
5 0
Replacing the bulbs for the front turn
i ndicator flashers and parking lights
Remove the two Phillips screws which hold
the glass. The bulbs can now be removed
by pressing them inwards and then turning
them a little anti-clockwise. The inner bulb
(1) is for the parking light, the outer (2)
for the turn indicator.
Replacing the foglight bulbs
The bulbs for the foglights are replaced
from inside the engine compartment.
Remove the protection covering the space
over the headlight and foglight. Squeeze
the spring holding the bulb and lift out the
spring and bulb. The bulb is now accessible
for replacement.
Because of the two bosses on the bulb
holder, the bulb can only be fitted in one
way.
r