Volvo 164 Owner's Manual - page 53
SERVICING
Replacing the bulbs for the rear turn
i ndicators, parking lights, stop lights
and reversing lights
Make sure that the sealing strip fits well
against the glass when it is re-fitted.
52
Remove the four Phillips screws which hold
the glass. The bulbs can now be removed
by pressing them inwards and turning them
slightly
anti-clockwise at the same time.
They are as follows:
1. Turn indicator
2. Reversing light
3. Rear light
4. Stop light
plate lighting
Replace bulb for glove locker
Replacing the bulbs for the license
The license plate lighting is provided with
t wo bulbs. Should any of them require re-
placing, proceed as follows:
1. Press in the tab catch in the bulb hous-
i ng by inserting a screwdriver in the
opening on the left-hand side of the
housing. Pull the bulb housing out of its
attachment.
2. Pull out the casing end not provided with
a guide pin.
3. The bulb is now accessible for replacing.
When fitting the unit, first insert the guide
pins in the sockets (see picture) and then
press on the casing. Check that the rubber
strip fits properly in position and press the
lamp housing securely into position.
Replace bulbs for instrument lighting,
switches and heater control lighting
Owing to the location of the bulbs, their re-
placement should be carried out by a Volvo
workshop.
Pull the bulb plastic cover straight down.
The bulb is then accessible for replacement.