Volvo 164 Owner's Manual - page 70
LUBRICATING CHART
Notes to lubricating chart
Note 1.
The wheel bearings are packed
at the factory with a special type of grease
i ntended to . last the entire lifetime of the
bearings. In connection
with
any
work-
shop operations involving uncovering the
wheel bearings, the bearings should be
cleaned and then lubricated with high-class,
durable grease according to the instructions
i n the service manual. Except on the above
occasion, subsequent adding or changing
of lubricant is not required.
Note 2. Power steerin
g
: Check that the oil
l evel in the power steering oil container is
5-10 mm (5/16") above the level
mark.
Use Automatic Transmission Fluid. Type A
or Dexron.
Note 3.
Check that the fluid reaches up
to the
MAX mark. (For right-hand drive,
check also clutch fluid level.)
Note 4. Lubricate the felt wick under the
rotor and fill a few drops of light engine
oil into the lubricating cup.
Note 5.
Check every 10 000 km (6 000
miles) that the oil reaches up to the filler
plug. Concerning oil change, see page 42.
NOTE. The type of gearbox (standard or
automatic) will decide the type of lubricant
to be used.
Note 6.
Change the oil filter every 10 000
km (6 000 miles). See page 44.
Note 7.
Check the oil level when filling
the tank.
Concerning
oil
changing,
see
page 41.
Note 8.
Check every 10 000 km (6 000
miles) that the oil reaches up to the filler
plug.
Concerning lubricant for rear axle
with differential lock, see page 43.
Oil capacities
69
Engine, oil change quantity
approx. 5.2 dm
3
/litres (9.0 Imp. pints)
i ncl. oil filter
approx. 6.0 dm
3
/litres (10.6 Imp. pints)
Gearbox M 400
approx. 0.6 dm
3
/litres (1.1 Imp. pints)
M 410
approx. 1.4 dm
3
/litres (2.5 Imp.pints)
BW 35 (automatic)
approx. 8.2 dm
3
/litres (14.4 Imp. pints)
Rear axle
approx. 1.6 dm
3
/litres (2.8 Imp. pints)
Power steering
approx. 1.1 dm
3
/litres (1.9 Imp. pints)