W Audio CR-6 User Manual - page 4

Features 

• Six lines including one phono, three microphone inputs

• Microphone 1 is equipped with auto-override, sensitivity adjustment, delay time, EQ, and gain.

• Balanced microphone inputs on front and rear panels

• (Front panel) Channel on/off switches

• Dual zone assignment for all inputs

• Two zone outputs with gain, pan, EQ, and stereo/mono selection

• Zones have unbalanced and balanced outputs with master gain reduction

• Headphone output with volume control 

Front panel:

1. Input gain knobs (6 channels): Control individual source levels.

2. On/off switches: Allow input sources to be individually selected. 

3. Zone assign: Determines which zone the audio is directed to. The A+B position sends audio to 

    both Zones.  

4. Microphone 1 Gain control: Controls the mic volume for the Neutrik combo connector on the 

    front panel. 

5. Microphone EQ controls: Adjusts the Treble, Mid and, Bass frequencies of the microphone inputs. 

6. Neutrik Combo Connector: Allows connection of either a 1/4” jack or an XLR plug. 

7. Zone Knob:Controls the output level. 

8. Mono/ Stereo: Selects the mode for the sound output. 

9. Pan: Controls the mix of stereo audio. Moved to the left only the left speakers will be heard, or to 

    the right for the right speakers.  

10. Level Indicator: Shows the level of sound output. 

11. Zone EQ: Adjusts the Treble, Mid and Bass frequencies of the zoned audio.

12. Headphone Gain Control: Adjusts the headphone volume.

13. Headphone Jack: for headphones connection. 

4