W Audio CR-6 User Manual - page 5
Features
Rear view:
14. Power Switch: Turns the unit on and off.
15. Power supply input: Insert the power adapter before switching on.
16. Balanced Zone B outputs: 1/4” stereo balanced 1/4” jack connectors controlled by the
Zone B knob.
17. Balanced Zone A outputs: Balanced stereo XLR connectors controlled by the Zone A knob.
18. Master Gain Reduction: Sets the output level of the Zone A outputs from 0.245V to 2.5V to
match the optimum inputs of amplifiers.
19. Unbalanced Zone Outputs: Output controlled by the Zone knobs.
20. Record Output: Mix of output sent to either zone.
21. Unbalanced Line Inputs: For connection of DVD players, CD players, tuners, or other
mixing consoles.
Note: a. Plug mono audio sources into both Left and Right inputs using a “ Y “ cable connector.
b. Line 3 can receive a turntable input depending on phono/line switch position.
22. Phono/Line Switch: Select the appropriate position for your input device. With phono selected
the input signal is fed directly to the high-quality RIAA phono pre-amplifiers so use this input only
for turntables. Line level sources will overload the sensitive phono pre-amps. Switch this over to
the Line position for line devices such as CD players and mixing consoles.
23. Ground connection: Use these connections with your turntables’ grounding cable to avoid
signal hum.
24. Combo Jack/XLR connector: Allows connection of either a 1/4” jack (line level) or an XLR
(microphone level) depending upon switch (25) position.
25. Mic/Line switch: Balanced XLR input for microphones, balanced Jack input for line level sources
26. Auto-Talkover Control: Sets the front panel Microphone to automatically reduce other source
levels when the mic is spoken into. Positions are available for either, -12dB, and -40dB
(complete reduction).
27. Talkover sensitivity adjustment: Determines the point in which auto-override activates.
The more sensitive the adjustment, the quieter you need to speak into your microphone to
activate auto-talkover.
28. Delay Time: Changes the speed and the music inputs return to normal volume after a
microphone is used. The time the music takes to return to the pre-set volume varies
from 0.5~ 4 seconds.
55