Waeco CF-110 Instruction Manual - 6.5
15
CoolFreeze
Operation
6.5
Using the cooler
Caution – Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the
heated air can dissipate.
➤ Close the cooler, see “Connecting the cooler” on page 12.
Note:
If you wish to operate the cooler from the AC mains, set the battery
monitor to the “LOW” position. See “Using the battery monitor” on
page 14.
Caution – Danger from excessively low temperature!
Ensure that the only objects placed in the cooler are those intended to
be cooled at the selected temperature.
➤ Press the “ON/OFF” button (Fig.
2
1, page 4) and hold down for
between one and two seconds.
✔ The ‘POWER” LED is lit green.
✔ The display (Fig.
2
6, page 4) switches on and shows the current
temperature in °C.
Note – Displayed temperatures
CF-80
i)
With plastic dividers in: the display temperature is that of the
middle of the freezer compartment (furthest away from main
control panel).
ii)
With plastic dividers removed: the actual compartment temperature
will be considerably warmer than the displayed temperature.
CF-110
i)
The temperature displayed is that of the middle of the large interior
compartment.
Temperatures elsewhere in the compartment (both models) will
deviate from the displayed temperature.
✔ The cooler starts cooling the interior.
CF80-110_M_70501 23/5/07 10:49 AM Page 15