1. DL manuals
  2. Waeco
  3. Water Dispenser
  4. CF-110
  5. Instruction Manual

Waeco CF-110 Instruction Manual - Function Description

Manual is about: Compressor Cooler

Summary of CF-110

  • Page 1

    M_70501 cf-80 ac cf-110 ac cf-80, cf-110 a au uss compressor cooler instruction manual cf80-110_m_70501 23/5/07 10:49 am page 1.

  • Page 2: Contents

    3 coolfreeze please read this operating manual carefully before starting the device. Keep it in a safe place for future reference. If the device is handed over to another person, this operating manual must be handed over along with the device. Contents 1. Notes on using the manual .....................

  • Page 3

    4 coolfreeze 2 ° 1 4 3 on off set power up + down – error ° 1 3 4 5 6 7 2 100-240v~ac fuse 1 2 12/24v dc 3 4 1 2 3 cf80-110_m_70501 23/5/07 10:49 am page 4.

  • Page 4

    5 coolfreeze on off turbo power error ∞ c temp + temp ñ on off turbo power error ∞ c temp + temp ñ 1 2 4 5 cf80-110_m_70501 23/5/07 10:49 am page 5.

  • Page 5

    6 coolfreeze 1 2 6 8 on off turbo powe r error c temp + temp ñ 7 cf80-110_m_70501 23/5/07 10:49 am page 6.

  • Page 6: Notes On Using The Manual

    7 coolfreeze notes on using the manual 1. Notes on using the manual the following symbols are used in this operating manual: caution! Safety instruction : failure to observe this instruction can cause personal injury or damage the device. Caution! Safety instruction : relating to a danger from an el...

  • Page 7: •

    8 coolfreeze safety instructions • only connect the device as follows: – using the cable supplied (fig. 1 2, page 4) to a 12- v or 24- v battery – or with the ac cable supplied (fig. 1 3, page 4) to the 100–240v ac mains. • if the connection cable is damaged, it must be replaced to prevent possible ...

  • Page 8: •

    9 coolfreeze intended use • warning! • do not place any electrical devices inside the cooler. • set up the device in a dry location where it is protected against splashing water. • protect the device and the cable against rain and moisture. • do not place the device near naked flames or other heat so...

  • Page 9: Function Description

    10 coolfreeze function description 5. Function description the cooler can chill products, keep them cool as well as freeze them. A low maintenance, cfc-free refrigerant circuit with compressor provides the cooling. The extra strong cfc-free insulation and powerful compressor ensure especially fast c...

  • Page 10: 5.2

    11 coolfreeze operation 5.2 connections connection sockets (fig. 3 , page 4) item description 1 connection socket ac voltage supply 2 fuse holder 3 connection socket dc voltage supply 4 emergency switch 6. Operation 6.1 before initial use note: before starting your new cooler for the first time, you ...

  • Page 11: 6.2

    12 coolfreeze operation 6.2 energy saving tips • choose a well ventilated installation location which is protected from direct sunlight. • allow hot food to cool down first before you place it into the device. • do not open the cooler more often than necessary. • do not leave the lid open for longer ...

  • Page 12

    13 coolfreeze operation caution – danger of damaging the device! Make sure that the polarity is correct. ➤ before starting up the device for the first time, check whether the operating voltage and the battery voltage correspond (see type plate). ➤ make sure that the cable at the positive battery term...

  • Page 13: 6.4

    14 coolfreeze operation 6.4 using the battery monitor . The device is equipped with a multi-level battery monitor that protects your vehicle battery against excessive discharging when the device is connected to the on-board 12/24 v supply. If the cooler is operated when the vehicle ignition is switc...

  • Page 14: 6.5

    15 coolfreeze operation 6.5 using the cooler caution – danger of overheating! Ensure at all times that there is sufficient ventilation so that the heat generated during operation can dissipate. Ensure that the ventilation slots are not covered. Make sure that the device is sufficiently far away from w...

  • Page 15: 6.6

    16 coolfreeze operation 6.6 setting the temperature ➤ press the “set” button (fig. 2 4, page 4) once. ➤ use the “up +” (fig. 2 6, page 4) and “down -” (fig. 2 7, page 4) buttons to select the cooling temperature. ✔ the cooling temperature appears in the display for a few seconds. The display flashes ...

  • Page 16: Cleaning and Maintenance

    17 coolfreeze operation 6.10 replacing the device fuse caution – danger of electrocution! Disconnect the connection cable before you replace the device fuse. ➤ pull off the connection cable. 6.11 replacing the light bulb ➤ press the switch pin (fig. 8 2, page 6) downwards so that the transparent par...

  • Page 17: Guarantee

    18 coolfreeze troubleshooting possible cause battery voltage is too low. No voltage present in the ac voltage socket. The device fuse is defective. The integrated mains adapter is defective. Defective compressor. Battery voltage is too low. The appliance has switched off due to an internal fault. Su...

  • Page 18: 10.

    10. Disposal ➤ place the packaging material in the appropriate recycling waste bins wherever possible. If you wish to finally dispose of the device, ask your local recycling centre or specialist dealer for details about how to do this in accordance with the applicable disposal regulations. 11. Techni...

  • Page 19

    20 coolfreeze a au uss n nzz internet http://www.Waeco.Com.Au http://www.Waeco.Co.Nz waeco western australia 9 hod way malaga wa 6090 phone: 1800 21 21 21 fax: (08)9209 3577 waeco new zealand unit 15, 180 montgomerie road airport oaks, auckland 1701 phone: 0800 676 000 fax: (09)256 0017 e-mail: info...