WAGNER Power Painter Owner's Manual - page 13
English
13
12. Insert nozzle into the end of
the suction tube and place into
a waste container.
Turn on the water and flush
the suction tube until clean.
11. Thread the cleaner nozzle onto
a garden hose.
8. Clean all parts thoroughly with
the brush provided using a
solution appropriate to the type of
material you sprayed.
9. ImpoRTANT: make sure to completely
remove all material from the inside of the
piston chamber by scrubbing with the
brush. Even a small amount of material
can dry like glue and keep the piston from
moving, causing damage to the sprayer.
10. ImpoRTANT: make sure to keep the vent
hole (a) on the pump housing clean and
unblocked or a vacuum can build up in
the container and cause damage to the
sprayer. A toothpick or straightened paper
clip can be used to clean it.
13. Using the cleaning brush and
mineral spirits, clean out the
inside of the suction tube.
14. Lubricate the O-rings as
shown with the included
lubricant.
Reassemble the filter
assembly.
LATEx MATERIALS ONLY
OIL-BASED MATERIALS ONLY
12
11
(a)
(a)
(b)
8
9
10
13
14