WAGNER Power Painter Owner's Manual - Cleanup
English
14
Cleanup
(remote suction
hoses / backpack kit)
Start
You will need:
• Waste container
• Cleaner nozzle
• Warm soapy water if you sprayed latex
materials
• Mineral spirits if you sprayed oil-based
materials
make sure you clean the sprayer in a
well-ventilated area whenever
cleaning with flammable solvents.
The sprayer contains electrical parts.
Do NoT submerge the sprayer into
any liquids.
1. Unplug the sprayer.
Remove the remote suction set from the
material container / backpack assembly
and submerge into a container of the
solvent appropriate to the type of material
you sprayed.
2. Plug in the sprayer.
Squeeze the trigger and
spray into a waste container
until the cleaning solution
comes through the sprayer
for a couple of minutes.
3. Unplug the sprayer.
Remove the remote suction
set housing from the sprayer.
Remove smaller return hose
from suction set housing.
7. Reattach the smaller
return hose to the dual
hose fitting.
Follow steps 4-10 in
Cleanup - Cup mode
(page 12).
5. Thread the cleaner
nozzle onto a garden
hose.
4. Disassemble the remote suction set
housing.
Clean all parts by hand using the
cleaning brush and the appropriate
cleaning solution.
Reassemble.
Note: If you used the
backpack kit, be sure
to clean the suction
tube and the inside of
the backpack by hand
using the appropriate
cleaning solution.
6. Insert nozzle into one of
the remote suction hoses.
Place the other end of
the hose into a waste
container.
Turn on the water and
flush the hose until clean.
Repeat for the other
hose.
LATEx MATERIALS ONLY
1
2
3
5
7
6
4