WAGNER Power Painter Owner's Manual - Troubleshooting
This unit has no servicable electrical parts.
Do not attempt to service this unit yourself.
English
17
Problem E: Excessive fogging
Cause
Solution
1.
Material selector set too high
Set material selector to ‘STAIN’
2.
Holding sprayer too far from work surface
Hold sprayer closer to work surface
Problem F: Runs and sags in paint
Cause
Solution
1.
Arm movement too slow, holding spray gun too close or work
surface, or applying too much paint at one time
See section on spraying (page 8)
Problem G: Material drips from spray tip or guard
Cause
Solution
1.
guard is for safety and cannot be removed. Some dripping is
unavoidable with some paints
Use a small brush on drips that fall on surface being sprayed. Use a drop cloth
Problem H: Material leaking from between spray tip and locking nut.
Cause
Solution
1. Spray tip is loose
Tighten securely
2. Atomizer valve not positioned properly
Unplug the sprayer, remove the spray tip and reposition the atomizer valve
3. Worn atomizer valve
Replace
4. Eroded pump housing
Replace the pump housing
Problem I: Motor overheats
Cause
Solution
1. Seized piston
Clean piston
2. Extension cord too long
Replace with proper size
3. Operating continuously
Release trigger at the end of a pass, allow to cool.
Troubleshooting
Have you tried the recommendations above and are still having problems? In the
United States, to speak to a customer service representative, call our Customer Service
at 1-800-328-8251 monday through Friday between 8:00 Am and 4:30 pm Central time.
Questions?
Call Wagner Technical Service at:
1-800-328-8251
Register your product online at:
www.wagnerspraytech.com
Proper registration will serve as proof of
purchase in the event your original receipt
becomes misplaced or lost.