WAGNER Power Painter Owner's Manual - Reassembly /
English
15
Reassembly /
Maintenance
Start
You will need:
• Scrap piece of wood or cardboard
• Lubricant
Note:PowerPainterMaxonly - Refer to page
58 to see the proper way to repack the sprayer
and components ito the carrying case.
1. Slide the spring onto the front
end of the piston.
Insert the piston into the back
of the pump housing.
5. Turn the sprayer upside-down
while the cup is removed.
Squeeze a small amount of
lubricant into both the intake
(a) and return (b) openings on
the pump housing.
4. Insert the atomizer valve into the
front end of the pump housing.
Place the adjustable spray tip
assembly onto the pump housing
and turn the tip nut clockwise
until it is tightened securely.
2. Insert the pump housing
assembly into the front of the
sprayer.
6. Plug in the sprayer. Aim
at piece of scrap wood or
cardboard and squeeze the
trigger of the sprayer for 2 to
3 seconds while sprayer is still
inverted.
7. Reassemble and reattach
the filter and suction tube
assembly.
Lubricate the O-ring (c) as
shown with the included
lubricant. Replace the cup.
3. Place the locking nut onto
the pump housing. Press in
while turning the locking nut
clockwise.
Do not cross-thread the
locking nut. make certain it
is threaded correctly before
tightening.
1
(a)
(b)
5
4
2
6
3
7
(c)