Waldorf AFB 16 User Manual - Setup and Connection
Setup and Connection
11
AFB16 User´s Manual
Setup and Connection
Inventory
The Waldorf AFB16 comes in a box that includes:
•
AFB16 hardware unit,
•
Power cable and high-speed USB cable,
•
CD-ROM with AFB installer and VST plug-ins, and
•
This manual, including a warranty card on page 74.
Please ensure all of these items were included. If
something is missing, contact the dealer where you
purchased the unit for replacements.
We recommend that you save the original packing
material for future transport.
!
Make sure you fill out the warranty card and send it
to your Waldorf distributor or to the address
printed on the card. This is the best way for us to
keep you informed of updates and upgrades.
Setup
Place the AFB16 on a clean, even surface. We
recommended installation in a stable 19-inch rack.
Connections
In order to get started with the AFB16 you will need an
AC power outlet and a compatible computer with USB
2.0 interface.
!
The AFB16 can not work in “stand-alone“ mode - it
always needs a computer to operate.
☞
To connect the device:
1. Make sure your computer and the AFB16 are
turned off.
2. Connect the power cable to the Power Supply
'
jack on the rear panel of the AFB16. Plug the
other end of the cable into a suitable AC power
outlet.
3. Connect the USB 2.0 jack of the AFB16 to a USB
2.0 interface port on your computer using the
supplied cable.
4. Switch your computer on.
5. Install the AFB driver as described on the next
page.