Waldorf AFB 16 User Manual - Pattern Selection
Waldorf ROT Analog Filter Step Sequencer VST Plug-In
25
AFB16 User´s Manual
Pattern Selection
Each ROT Program has eight quick-save memory
locations for instant recall of cutoff and resonance
patterns. To activate one of these patterns, click on one of
the eight buttons at the top of the plug-in window.
!
Only the steps are stored in these slots, and not the
other filter parameters. Therefore, when you switch
slots only the patterns will change. All eight patterns
and the corresponding filter settings are saved with
the program.
Copying patterns
You can copy a pattern into an internal buffer and paste it
back to another pattern.
☞
Copying and pasting a pattern
1.
Select the source pattern.
2.
Press the Copy button. The source pattern is copied
into the internal buffer.
3.
Select the target location where you want to paste
the contents of the buffer.
4.
Press the Paste button. The copied pattern will be
pasted into the target location.
Additional Parameters
If your host application sends timing information
to VST plug-ins, ROT will be automatically
synchronized to the master tempo it provides.
The following parameters will give you even
more control over the rhythmic variations.
Clock
1/64t...8 bars
Sets the note value for the steps of the rhythm pattern.
Triplets (e.g. 1/8T) and dotted notes (e.g. 1/16.) are also
available.
Swing
0...100%
Determines how much the steps are rhythmically delayed.
If Swing is set to 0 the pattern is played back without any
shuffled timing. Settings from 1% to 100% increase the
shuffle of the steps.
Length
1...16
Sets the step length of the pattern. The selected steps are
displayed in the cutoff and resonance matrix.